Integra LS Coupe L4-1834cc 1.8L DOHC MFI (1997)
Reverse Idler Gear: Testing and Inspection
CLEARANCE INSPECTION
1. Measure the clearance between the reverse change holder and the 5th/reverse shift piece pin.
-
Standard:
Reverse Side: 0.05 - 0.45 mm (0.002 - 0.018 inch).
5th Side: 0.4 - 0.9 mm 10.02 - 0.04 inch).
2. If the clearance are not within the standard, measure the width of the grooves in the reverse change holder.
-
Standard:
Reverse Side: 7.05 - 7.25 mm (0.278 - 0.285 inch).
5th Side: 7.4 - 7.7 mm (0.29 - 0.30 inch).
-
If the width of the grooves are not within the standard, replace the reverse change holder with a new one. If the width of the grooves are within
the standard, replace the 5th/reverse shift piece with a new one.
3. Measure the clearance between the reverse idler gear and the reverse change holder.
-
Standard: 0.5 - 1.1 mm (0.02 - 0.04 inch).