Integra LS Sedan L4-1834cc 1.8L DOHC MFI (1999)
Ignition Coil: Testing and Inspection
IGNITION COIL / TEST
1. With the ignition switch OFF, remove the distributor ignition (DI) cap.
2. Remove the two screws to disconnect the BLK/YEL and WHT/BLU wires from terminals A (+) and B (-) respectively.
3. Using an ohmmeter, measure resistance between the terminals. Replace the coil if the resistance is not within specifications.
NOTE: Resistance will vary with the coil temperature; specifications are at 68°F (20°C)
Primary Winding Resistance
(Between the A and B terminals): 0.6 - 0.8 ohms
Secondary Winding Resistance
(Between the A and secondary winding terminals): 12.8 - 19.2 k ohms