Integra LS Sedan L4-1834cc 1.8L DOHC MFI (1999)
Air Bag Control Module: Service and Repair
CAUTION:
- Before disconnecting the SRS main harness 18P connector, disconnect the airbag connectors.
- During installation or replacement, do not bump (impact wrench, hammer etc.) the area near the SRS unit.
- Do not damage the SRS unit terminals or connectors.
- Do not disassemble the SRS unit; it has no serviceable parts.
- Store the SRS unit in a clean, dry area.
- Do not use any SRS unit which has been subjected to water damage or shows signs of being dropped or improperly handled, such as dents, cracks or
deformation.
1. Disconnect the battery negative cable, then disconnect the positive cable from the battery, and wait at least three minutes.
2. Disconnect the airbag connectors. (When disconnected, the airbag connectors are automatically shorted.)
Driver's Side
Remove the access panel from the steering wheel, then disconnect the 2P connector between the driver's airbag and cable reel.
Front Passenger's Side
Disconnect the 2P connector between the front passenger's airbag and SRS main harness.
SRS Unit Replacement
3. Remove the right side cover from the SRS unit.