Integra LS Sedan L4-1834cc 1.8L DOHC MFI (1999)
4. Attach a hose to the end of the valve as shown.
5. Submerge the valve in a container of power steering fluid or solvent, and blow in the hose. If air bubbles leak through the valve at less than 98
kPa (14.2 psi), replace the pump as an assembly.
6. If the flow control valve tests OK, reinstall it in the pump. If the flow control valve still leaks air, replace the pump as an assembly. The flow
control valve is not available separately.
Ball Bearing:
1. Inspect the ball bearing by rotating the outer race slowly. If any play or roughness is felt, replace the ball bearing.
2. Replace the ball bearing using a press.
REASSEMBLY
1. Install the new pump seal in the pump housing by hand, then install the pump seal spacer.
NOTE: Insert the pump seal with its grooved side facing in.