Integra LS Sedan L4-1834cc 1.8L DOHC MFI (1999)
Steering Gear: Service and Repair
Removal and Installation
REMOVAL
NOTE: Using solvent and a brush, wash any oil and dirt off the valve body unit, its lines, and the end if the gearbox. Blow dry with compressed air.
1. Drain the power steering fluid.
2. Raise the front of vehicle, and support on safety stands in the proper locations.
3. Remove the front wheels.
4. When the vehicle is equipped with the SRS airbag system, remove the steering wheel.
5. Remove the steering ring gear.
6. Remove the steering joint lower bolt, and move the joint toward the column.
7. Remove the cotter pin from the ball joint pin and remove the nut.
8. Install the 10 mm hex nut on the ball joint.
Be sure that the 10 mm hex nut is flush with the ball joint pin end, or the threaded section of the ball joint pin might be damaged by the ball joint
remover.
NOTE: Remove the ball joint using the special tool.