Integra LS Sedan L4-1834cc 1.8L DOHC MFI (1999)
8. Fit the inboard joint onto the driveshaft.
NOTE:
-
Reinstall the inboard joint onto the driveshaft by aligning the marks on the inboard joint and the rollers.
-
Hold the driveshaft so the inboard joint points up to prevent it from falling off.
9. Fit the joint boot ends onto the driveshaft and joints.
When installing the outboard joint boot on a Canada model, be sure the end of the boot is seated in the grooves of the driveshaft and outboard
joint.
10. Adjust the length of the driveshafts to the specifications below, then adjust the boots to halfway between full compression and full extension.
NOTE: The ends of boots seat in the groove of the driveshaft and joint.
