Integra LS Sedan L4-1834cc 1.8L DOHC MFI (1999)
-3. Make a mark on the band 10 - 14 mm (0.4 - 0.6 inch) from the clip.
-4. Thread the free end of the band through the nose section of the commercially available boot band tool (KD-3191 or equivalent), and into the
slot on the winding mandrel.
-5. Place a wrench on the winding mandrel of the boot band tool, and tighten the band until the marked spot on the band meets the edge of the
clip.
-6. Raise up the boot band tool to bend the free end of the band 90 degrees to the clip.
Center punch the clip, then fold over the remaining tail onto the clip.
-7. Unwind the boot banding tool, and cut off the excess free end of the band to leave a 5 - 10 mm (0.2 - 0.4 inch) tail protruding from the clip.
