Integra LS Sedan L4-1834cc 1.8L DOHC MFI (1999)
2. Install the 80 mm shim.
NOTE: Install the 80 mm shim that was removed.
3. Install the transmission housing.
NOTE: Do not apply liquid gasket to the mating surface of the clutch housing.
4. Tighten the transmission housing attaching bolts.
8 x 1.25 mm 27 Nm (2.8 kgf.m, 20 ft. lbs.)
5. Use the special tool to bottom the differential assembly in the clutch housing.
6. Measure clearance between the 80 mm shim and bearing outer race in the transmission housing.
7. If the clearance is not within the standard, select a new 80 mm shim from the table.
Standard: 0 - 0.10 mm (0.004 inch)
