Integra LS Sedan L4-1834cc 1.8L DOHC MFI (1999)
CAUTION: Hold the piano wire as close to the rear window as possible to prevent damage to the body and molding.
5. Cut the adhesive with a knife at the bottom of the rear window.
NOTE: Do not use piano wire in this area.
6. Carefully remove the rear window.
NOTE: Replace the fasteners with new ones whenever the rear window has been removed.
Installation
1. Scrape the old adhesive smooth with a knife to a thickness of about 2 mm (0.08 in) on the bonding surface around the entire rear window opening
flange.
NOTE:
-
Do not scrape down to the painted surface of the body; damaged paint will interfere with proper bonding.
-
Remove the upper and lower fasteners from the hatch.
-
Mask off surrounding surfaces before applying primer.
2. Clean the hatch bonding surface with a sponge dampened in alcohol.
NOTE: After cleaning, keep oil, grease or water from getting on the surface.
3. If the old rear window is to be reinstalled, use a putty knife to scrape off all traces of old adhesive, then clean the rear window surface with alcohol
where new adhesive is to be applied.
NOTE: Make sure the bonding surface is kept free of water, oil and grease.