Integra Type R Coupe L4-1797cc 1.8L DOHC (VTEC) MFI (2001)
NOTE: Do not rotate camshafts during inspection.
9. Remove the camshaft holders. Measure widest portion of plastigage strip on each journal.
Camshaft-to-Holder Oil Clearance:
Standard (New): 0.050 - 0.089 mm (0.0020 - 0.0035 inch)
Service Limit: 0.15 mm (0.006 inch)
10. If camshaft-to-holder oil clearance is out of tolerance:
-
And camshaft has already been replaced, you must replace the cylinder head.
-
If camshaft has not been replaced, first check total runout with the camshaft supported on V-blocks.
Camshaft Total Runout:
Standard (New): 0.03 mm (0.001 inch) max.
Service Limit: 0.04 mm (0.002 inch)
-
If the total runout of the camshaft is within tolerance, replace the cylinder head.
-
If the total runout is out of tolerance, replace the camshaft and recheck. If the oil clearance is still out of tolerance, replace the cylinder head.