Integra Type R Coupe L4-1797cc 1.8L DOHC (VTEC) MFI (2001)
_mfi/Page-3817002.png)
2. Make sure that the seat belt does not lock when the retractor is leaned slowly up to 15 degrees from the mounted position. The seat belt should
lock when the retractor is leaned over 40 degrees.
CAUTION: Do not attempt to disassemble the retractor.
3. Replace the seat belt with a new one if there is any abnormality.
On-the-Car Seat Belt Inspection
1. Check that the seat belt is not twisted or caught on anything.
2. After installing the anchors, check for free movement on the anchor bolts. If necessary, remove the anchor bolts and check that the washers and
other parts are not damaged or improperly installed.
3. Check the seat belts for damage or discoloration. Clean with a shop towel if necessary.
CAUTION: Use only soap and water to clean.
NOTE: Dirt build-up in the metal loops of the upper anchors can cause the seat belts to retract slowly. Wipe the inside of the loops with a clean
cloth dampened in isopropyl alcohol.
4. Check that the seat belt does not lock when pulled out slowly. The seat belt is designed to lock only during a sudden stop or impact.
5. Make sure that the seat belt retracts automatically when released.
6. For each passenger's seat belt, make sure that the locking mechanism in the seat belt retractor engages when the seat belt is pulled all the way out.
7. Replace the seat belt with a new one if there is any abnormality.
