Integra Type R Coupe L4-1797cc 1.8L DOHC (VTEC) MFI (2001)
6. Glue the lower fasteners and upper fasteners to the hatch as shown.
7. Set the rear window upright on the hatch, then center it in the opening. Make alignment marks across the rear window and body with a grease
pencil at the four points shown.
8. Remove the rear window.
9. Center and glue the side rubber dams to the inside face of the rear window, as shown, to contain the adhesive during installation.
NOTE:
-
Glue the side rubber dams, using the printed dots as a guide.
-
Be careful not to touch the rear window where adhesive will be applied.
-
Mask off surrounding surfaces before applying primer.