Legend V6-2494cc 2.5L SOHC FI (1986)
Yes - Replace the control box.[ ]
No - Go to the next step.
17.
Disconnect the 25-P connector from the transceiver and leave the 14-P connector disconnected from the control box.
18.
Set the DVOM to ohms. Then, at the 14-P connector, check for continuity between terminal 3 and ground.
Is there continuity?
Yes - Repair the shorted wire between the 25-P transceiver connector and the 14-P control box connector.[ ]
No - Go to the next step.
19.
Check for continuity between terminal 15 of the 25-pin connector and terminal 3 of the 14-P connector.
Is there continuity?
Yes - Go to the next step.
No - Go to step 21.
20.
Check continuity between terminal 3 of the 14-P control box connector and each of the other terminals in that connector.
Is there continuity between terminal 3 and any other terminal in the connector?
Yes - Repair or replace the shorted wires between the 25-P transceiver connector and the 14-P control box connector.[ ]
No - Replace the transceiver.[ ]
21.
Check the connections at both DIN connectors (one at the control box, one at the transceiver).
Are the DIN connectors OK?
Yes - Repair the open wire between the 25-P transceiver connector and the 14-P control box connector.[ ]
No - Repair the faulty DIN connectors.[ ]