Legend V6-2494cc 2.5L SOHC FI (1986)
Weatherstrip: All Technical Service Bulletins
Door Glass - Wind Noise
YEAR
MODEL
VIN APPLICATION
ALL
LEGEND COUPE
ALL
December 21, 1988
BULLETIN NO.
88-023
Wind Noise from the Door Glass
PROBLEM
Air leaks around the left or right door glass sealing area.
CORRECTIVE ACTION
Adjust the height, the fore/aft position, and the camber of the door glass as described below.
NOTE:
Before adjusting the door glass, check the overall fit of the door. If the door doesn't fit or close properly, that may be the cause of the wind
noise. If necessary, adjust the door as described in the Body section of the service manual.
PROCEDURE
1.
Roll down the rear quarter window on whichever side of the car you're working on. Then remove the door panel and speaker as described in the
Body section of the service manual.
CAUTION: Some of the center pillar molding clips will brook off when you remove the molding in the following step. Make sure you have a new
molding on hand.
2.
Remove the center pillar molding, then remove the upper weatherstrip from the top of the window opening and the center pillar. (Leave the
weatherstrip in place around the quarter window.) Remove the center and front pillar retainers, then pull the door trim away from the window
opening area.
3.
If you're working on the passenger's door, remove the window switch from the door panel, set the panel aside, and reconnect the switch to the door
wire harness.
If you're working on the driver's door, connect the Auxiliary Window Switch, T/N 07KAZ-001000A, to the door wire harness as shown below:
AUXLIARY WINDOW
DOOR WIRE
SWITCH WIRES
HARNESS CONNECTOR
RED
to
WHT/YEL
GRN
to
BLK/GRN