Legend V6-2494cc 2.5L SOHC FI (1986)
Fig. 17 Exhaust rocker arm installation. Legend
32.
Install exhaust rocker arm assembly as follows:
a. Apply clean engine oil to rocker shaft mounting surfaces.
b. Tap rocker arm shaft into position from transaxle side, then install rocker arms and wave washers, Fig. 17. Ensure wave washers are fully
seated in cylinder head groove.
c. Fully insert rocker shaft, then install sealing plug and torque to 36 ft. lbs. (33 ft. lbs on 2.7L engine).
33.
If lifters were removed, pour engine oil into lifter bores up to level of oil path, then install lifters into cylinder head without rotating. Pour oil into
oil filler holes in cylinder head.
Fig. 18 Exhaust inside rocker arm & intake rocker arm installation. Legend
34.
Install push rods, then the exhaust inside rocker arm and intake rocker arms, Fig. 18.
35.
Install camshafts and camshaft oil seals, noting the following:
a. Ensure camshaft in front position has a groove for driving the distributor.
b. Ensure camshaft is positioned parallel with rocker arm slipper surface.
c. To prevent interference between piston and valve, advance crankshaft by 15° from TDC of compression stroke on cylinder No. 1.
d. Position camshaft in rear position on cylinder head so cam is not pushing the valve.
e. Position oil seals with spring side facing inward.