Legend V6-2494cc 2.5L SOHC FI (1986)
Suspension Strut / Shock Absorber: Service and Repair
Front Suspension Torque Specification
CAUTION:
- Replace the self-locking nuts after removal.
- Replace the self-locking bolts if you can easily thread a nut past their nylon locking inserts.
NOTE: Wipe off the grease before tightening the nut at the ball joint.
CAUTION: Before tightening the bolts or nuts connected to rubber mounts or bushings, the vehicle should be on the ground.
Upper Arm/Stabilizer/Radius Rod/Lower Arm
Index/Inspection
CAUTION:
-
The radius rod bushings can easily be mis-installed; the thick radius rod bushing should be installed in the front position
-
R or L mark is stamped on the rear end of the radius arm to prevent mis-installation.