Legend Coupe V6-2675cc 2.7L SOHC FI (1988)
No - Go to the next step.
12.
Reconnect the 6-P connector to the control box, but leave the 2-P connector disconnected from the microphone. The phone should be on.
13.
Set the DVOM to volts, then backprobe the 2-P connector at terminal 1 and measure voltage to around.
Is there about 9.5 volts?
Yes - Replace the microphone.[ ]
No - Go to the next step.
14.
Backprobe the 14-P control box connector at terminal 3 and measure voltage to ground (the microphone must remain disconnected).
Is there about 9.5 volts?
Yes - Replace the control box.[ ]
No - Go to the next step.
15.
Disconnect the 14-P connector from the control box. Then disconnect the handset from the console and take it to the trunk. Open the trunk,
remove the rubber plug from the socket in the underside of the transceiver, and plug the handset into that socket.
16.
At the 14-P connector, check for voltage between terminal 3 and ground.
Is them about 9.5 volts?
