Legend Coupe V6-2675cc 2.7L SOHC FI (1988)
12.
Slowly lower the window until the glass stoppers are even with the lower door stiffener beam. Make sure there's at least 3 mm of clearance
between the glass stoppers and the beam.
13.
Reinstall the door trim, the center and front pillar retainers, the speaker, and the door panel.
14.
If your last measurement for position 11 was greater than 18 mm, go to step 15. If the measurement was 18 mm or less, go to step 16.
15.
Using a single-edged razor blade or utility knife, split the door glass side of the center pillar seal lengthwise down the back, as shown. Cut a
20 x 300 mm piece of EPT sealer 10t. Fold the EPT length-wise so the adhesive side sticks together. Insert the EPT inside the center pillar
seal. Close the center pillar seal with "Super Glue" (cyano acrylate adhesive), then weather-proof the seal with weatherstrip adhesive.
16.
Reinstall the upper weatherstrip and the center pillar molding. Seal the ends of the weatherstrip with black weatherstrip adhesive as shown.
PARTS INFORMATION
Center pillar molding, Right: P/N 72525-SG0-003
Left:
P/N 72575-SG0-003
Washer, 22 x 8 x 2 mm: P/N 90509-642-000
EPT sealer, 10t: P/N 06992-SA5-000
WARRANTY CLAIM INFORMATION
Operation number:
835025 (one side) 836030 (both sides)
Flat rate time:
1.8 hours (one side) 3.6 hours (both sides)
