Legend Coupe V6-2675cc 2.7L SOHC FI (1988)
3.
Use a screwdriver with a magnetic tip to install a set screw in the buckle guide on the same side that you installed the anchor plate. As you tighten
the set screw, push down on the buckle guide to make sure it is fully on the buckle.
NOTE:
Tighten the screw by hand or with a low-torque battery-operated screwdriver. A pneumatic or high-torque screwdriver will strip the guide and
anchor plate.
4.
Repeat steps 1 through 3 on the other front seat belt buckle.
5.
Center-punch a completion mark below the first character of the engine compartment VIN.
