Legend Coupe V6-2675cc 2.7L SOHC FI (1988)
5.
Position a trash can underneath the driveshaft to catch the outboard joint.
6.
Place the head of a brass mallet on the inner race of the outboard joint. Using a large steel ball peen hammer, strike the head of the brass mallet
sharply two or three times.
7.
If the outboard joint does not come loose after two or three hits, rotate the driveshaft 180° and try again from the opposite side. If the joint still will
not come loose, replace the driveshaft assembly.
8.
Remove the driveshaft from the vise.
CV Shaft And Retainer Clip
9.
Remove and discard the "C" clip from the driveshaft. Clean and inspect the driveshaft splines and ring groove for burrs or other defects.
10.
Install the new outboard joint boot provided in the kit. Slide it slowly onto the driveshaft to avoid damaging the boot.
11.
Install the new "C" clip in the ring groove of the driveshaft.
