Legend Coupe V6-2675cc 2.7L SOHC FI (1988)
8.
Modify a # 30 drill bit so it cannot dhll any deeper than 10 mm. Use a piece of tape, piece of hose, or recess the bit into the chuck. Drilling too
deep can damage components inside the door.
9.
Using the reinforcement plate pre-drilled holes as a template, drill 16 holes in the inner door skin.
10.
Pop rivet the reinforcement plate in place.
11.
Adjust the door glass. Refer to Service Bulletin 88-023, Wind Noise from the Door Glass, dated December 21, 1988.
12.
Reinstall the wire harness ties and the plastic cover.
13.
Reinstall the speaker, door panel bracket, power window controller, door panel, door handle trim plate, and cap.
Passenger's Door
1.
Remove the door panel. Use a razor blade to carefully cut the adhesive holding the plastic cover. Remove the plastic cover from the door.
2.
Remove the window mounting nuts. Remove the window from the door.
3.
Remove seven regulator mounting bolts. Loosen two motor mounting bolts. Remove the regulator from the door.
4.
Inspect the inner door skin around the holes for the regulator mounting bolts. Use a MIG welder to repair any cracks in the metal.
