Legend Coupe V6-3206cc 3.2L SOHC FI (1991)
Body Control Module: Diagnostic Aids
Electronic Component Handling
STATIC DISCHARGE
^
Discharge any static electrical charges before handling electronic parts by touching ground or maintaining a ground connection to a bare skin area
like the wrist.
^
Never touch the ECU connector pins, integrated circuit connector pins, or soldered components on the ECU circuit board.
TESTING
^
When measuring voltage at the control unit harness connector, disconnect harness connector with the ignition OFF, then turn ignition "ON" as
necessary.
^
To prevent deforming control unit harness connectors, do not probe terminals directly. Instead, insert a pin from the harness side and perform
measurements through pin.
CONTROL UNIT DAMAGE
^
Do not try to disassemble the control unit.
^
Before performing electrical welding (for instance, spot welding), disconnect the battery, climate control, injection, cruise control, ECU and radio.
^
If temperatures may exceed 176°F (80°C), (example: infra-red spray booth), remove all ECU's.
^
Avoid getting water on any of the Fuel and Engine Control System Components.
^
Never apply battery power to a component unless directed to do so in a test procedure.
