Legend Coupe V6-3206cc 3.2L SOHC FI (1991)
20.
Center the seat on the tracks by applying 12 volts to the fore/aft slide motor connector. Use a two-pin male connector with extension leads so you
do not damage the motor connector.
21.
Remove and discard the link bolt attaching the screw shaft of the rear elevation motor to the rear joint link.
22.
Remove and retain the two 5 mm crossbrace bolts.
23.
Remove the three 6 mm rear elevation motor assembly mounting nuts. Remove the motor assembly.
[NEW] 24. If the screw shaft of the rear elevation motor was diagnosed as being loose, replace the motor assembly. If the screw shaft was diagnosed as
being tight, remove the old bushing from the screw shaft.
[NEW] 25. Install a new bushing from the kit in the screw shaft of the rear elevation motor. Install the bushing so the split is facing the floor of the car.
Flare the end of the bushing with a smooth, rounded object.
[NEW] 26. Install the rear elevation motor assembly. Tighten the three mounting nuts to 10 N.m (1.0 kg-m, 7 lb-ft).
27.
Reinstall the two 5 mm crossbrace bolts. Tighten the bolts to 5 N.m (0.5 kg-m, 3.6 lb-ft).
28.
Install a new link bolt from the bushing kit to attach the screw shaft of the rear elevation motor to the rear joint link. Tighten the link bolt to 10
N.m (1.0 kg-m, 7 lb-ft).
29.
Move the seat all the way back on the tracks by applying 12 volts to the fore/aft slide motor connector.
30.
Disconnect the rear joint link outer pivot points from the seat cushion brackets.
^
Right side - remove and retain the 6 mm nut and washer.
^
Left side - remove and discard the link bolt. Remove and retain the joint pivot bolt (Allen head).
31.
Install three new bushings. Insert the bushings so the split is facing the floor of the car. Flare the ends of the bushing with a smooth, rounded
object.
32.
Reinstall the joint pivot bolt. Install a new link bolt from the bushing kit. Reinstall the 6 mm washer and nut. Tighten all three to 10 N.m (1.0
kg-m, 7 lb-ft).
33.
Reconnect the motor power and pulser connectors, and install the connectors on the motor assembly brackets.
34.
Reinstall the cushion front, recline, and height covers onto the seat.
