Legend Coupe V6-3206cc 3.2L SOHC FI (1991)
3.
Move the seat backward and upward as far as it will go. Remove the seat track covers and mounting bolts from the front of the seat.
4.
Coupe Only - Remove the plastic cap ann the lower anchor bolt from the seat belt presenter.
5.
Lift the front of the seat, and support it with a 10-inch-long piece of wood.
6.
Disconnect all electrical connectors, and remove the seat from the car.
7.
Remove the cushion front, recline, and height covers from the seat.
8.
Disconnect the four motor power and pulser connectors. Remove the front elevation motor power connector from the bracket on the rear elevation
motor. Remove the rear elevation motor pulser connector from the bracket on the front elevation motor.
9.
Remove and discard the link bolt attaching the screw shaft of the front elevation motor to the front joint link.
10.
Remove and retain the two 5 mm crossbrace bolts.
11.
Remove the three 6 mm front elevation motor assembly mounting nuts. Remove the motor assembly.
[NEW] 12. If the screw shaft of the front elevation motor was diagnosed as being loose, replace the motor assembly. If the screw shaft was diagnosed as
being tight, remove the old bushing from the screw shaft.
[NEW] 13. Install a new bushing from the kit in the screw shaft of the front elevation motor. Install the bushing so the split is facing the floor of the car.
Flare the end of the bushing with a smooth, rounded object.
[NEW] 14. Install the front elevation motor assembly. Tighten the three mounting nuts to 10 N.m (1.0 kg-m, 7 lb-ft).
15.
Install a new link bolt from the bushing kit to attach the screw shaft of the front elevation motor to the front joint link. Tighten the link bolt to 10
N.m (1.0 kg-m, 7 lb-ft).
16.
Reinstall the 5 mm crossbrace bolts. Tighten the bolts to 5 N.m (0.5 kg-m, 3.6 lb-ft).
17.
Remove and discard the two bolts attaching the front joint link outer arms to the seat cushion brackets.
18.
Install new bushings in these links. Insert the bushings so the split is facing the floor of the car. Flare the ends of the bushings with a smooth,
rounded object.
19.
Reattach the front joint link to the seat cushion brackets with two new bolts from the bushing kit. Tighten the bolts to 10 N.m (1.0 kg-m, 7 lb-ft).
