Legend Coupe V6-3206cc 3.2L SOHC FI (1991)
18.
Center the seat on the tracks by applying 12 volts to the fore/aft slide motor connector. Use a 2-pin male connector with extension leads so you do
not damage the motor connector.
19.
Remove the bolt linking the rear elevation motor assembly to the rear joint link. Discard the bolt. Remove the two 5 mm crossbrace bolts.
20.
Remove the three 6 mm rear elevation motor assembly mounting nuts. Remove the motor assembly.
NEW
21.
Install a bushing in the linkage arm of the new rear elevation motor. Install the bushing so the split is facing the floor of the car. Flare the bushing
end with a smooth, rounded object.
22.
Install the new rear elevation motor assembly. Tighten the three mounting nuts to 10 N-m (1.0 kg-m, 7 lb.ft.).
23.
Install the two 5 mm crossbrace bolts. Tighten to 5 N-m (0.5 kg-m, 3.6 lb.ft.).
24.
Install a new link bolt from the bushing kit. Tighten to 10 N-m (1.0 kg-m, 7 lb.ft.).
25.
Move the seat all the way back on the tracks by applying 12 volts to the fore/aft slide motor connector.
26.
Disconnect the rear joint link outer pivot points from the seat cushion brackets.
^
Right side - remove the 6 mm nut and washer.
^
Left side - remove and discard the link bolt. Remove the joint pivot bolt (allen head).
27.
Install three new bushings. Insert the bushings so the split is facing the floor of the car, flare the bushing ends with a smooth, rounded object.
28.
Reinstall the joint pivot bolt. Install a new link bolt from the bushing kit. Reinstall the 6 mm washer and nut. Tighten all three to 10 N-m (1.0
kg-m, 7 lb.ft.).
29.
Reconnect the motor power and pulser connectors and install the connectors on the motor assembly brackets.
30.
Reinstall the front, recline, and height covers.
31.
Place the seat in the car and reconnect the electrical connectors.
32.
Coupe Only - Install the lower seat belt pivot to the seat belt presenter. Tighten the bolt to 32 N-m (3.2 kg-m, 23 lb.ft.). Install the plastic cap.
33.
Install the four seat track mounting bolts and tighten them to 35 N-m (3.5 kg-m, 25 lb.ft.). Install the seat track covers.
34.
Install the headrest.
35.
Move the seat bottom and seat back through their full ranges to make sure they do not bind.
PARTS INFORMATION
Front elevation motor assembly: 81518-SP0-A21
Rear elevation motor assembly: 81519-SP0-A21
Bushing kit: 81510-SP0-305 (Kit includes 11 bushings and five bolts. Only seven bushings are required to do one seat.)
WARRANTY CLAIM INFORMATION
In warranty:
The normal warranty applies.
Out of warranty:
Any repair performed after warranty expiration may be eligible for goodwill consideration by the District Service Manager. You must request
consideration, and get the DSM's decision. before starting work.
Operation number: 851168
Flat rate time: 1.7 hours
Failed P/N: 81518-SP0-A21
