acura Workshop Repair Guides

Acura (Honda) Workshop Service and Repair Manuals

Customer Interest for Speedometer Head:|91048|Page 11240 > < Shift Position Console Switch Replacement|Page 11234
Page 1
background image

Speedometer Head: Customer Interest
Speedometer - Reads Too High

November 4, 1991

BULLETIN NO.
91-048

YEAR

MODEL

VIN APPLICATION

1991

LEGEND

ALL

Speedometer Reads Too High

SYMPTOM

The customer complains about the speedometer's accuracy.

CORRECTIVE ACTION

Adjust the speedometer so it reads closer to the actual speed.

NOTE:

This adjustment is not a calibration.

1.

Remove the gauge assembly.  Refer to page 23-138 of the service manual for the removal procedure.

NOTE:

To remove the courtesy light controller LS, refer to service bulletin 91-028.

2.

Remove the printed circuit panel cover (white plastic) from the back of the gauge assembly. Remove printed circuit panel B, then reinstall the
circuit panel cover.

3.

Reconnect the electrical connectors to the gauge assembly. Position the assembly so you can get at the back.

4.

Raise the front end of the car and support it securely.

5.

Start the engine and put the car in gear. Bring the speedometer up to 63 mph.

6.

Hold it at 63 mph for ten seconds and note the tachometer reading.

7.

Use a small screwdriver to turn the speedometer adjustment potentiometer counterclockwise until the speedometer reads 60 mph at the same 

Customer Interest for Speedometer Head:|91048|Page 11240 > < Shift Position Console Switch Replacement|Page 11234