Legend Coupe V6-3206cc 3.2L SOHC FI (1991)
Throttle Body: Recalls
Corrective Action
Replace the throttle body with the updated assembly listed under PARTS INFORMATION.
1.
Remove the throttle body cable cover.
2.
Remove the two hoses from the air inlet tube. Remove the resonator mounting bolt from the top of the radiator. Loosen the hose clamp and remove
the air inlet tube from the throttle body.
3.
Pinch off the coolant hoses so they will not leak; then, remove them from the throttle body.
4.
Disconnect all vacuum hoses from the throttle body.
5.
Remove the two bolts mounting the throttle cable bracket to the front of the throttle body.
6.
Disconnect the electrical connector from the throttle angle sensor.
7.
Remove the four throttle body mounting nuts. Remove the throttle body.
8.
Remove the throttle cable bracket mounting bolt from the underside of the throttle body. Disconnect the throttle cable and cruise control cable
from the linkage.
9.
Attach the throttle cable and cruise control cable to the linkage of the new throttle body. Install the bracket to the underside with the original bolt.
10.
Install the throttle body with a new gasket. Tighten the mounting nuts to 22 Nm (2.2 kg-m, 16 lb-ft).
11.
Reinstall the cable bracket mounting bolts in the front of the throttle body. Tighten the bolts to 10 Nm (1.0 kg-m, 7.3 lb-ft).
12.
Connect the electrical connector to the throttle angle sensor.
13.
Reinstall the vacuum hoses.
14.
Reinstall the coolant hoses.
15.
Reinstall the air inlet tube to the throttle body. Reinstall the resonator on top of the radiator. Connect the hoses to the air inlet tube.
