Legend Coupe V6-3206cc 3.2L SOHC FI (1991)
Clockspring Assembly / Spiral Cable: Service and Repair
Cable Reel Installation
Cable Reel Installation
CAUTION:
-
Before installing the steering wheel, the front wheels should be aligned straight forward.
-
Be sure to install the harness wires so that they are not pinched or interfering with other car parts.
-
After reassembly, confirm that the wheels are still straight ahead and that steering wheel spoke angle is correct. If minor spoke angle
adjustment is necessary do so only by adjustment of the tie rods, not by removing and repositioning the steering wheel.
1. Align the cancel sleeve grooves with the cable reel projections.
2. Carefully install the cable reel and the cancel sleeve on the steering column shaft. Reinstall the cover.
3. Install the steering column upper and lower covers.
4. Center the cable reel.
Do this by first rotating the cable reel clockwise until it stops.
Then rotate it counterclockwise (approximately two turns) until:
-
The yellow gear tooth lines up with the mark on the cover.
-
The arrow on the cable reel label points straight up.
