Legend Coupe V6-3206cc 3.2L SOHC FI (1991)
SRS Control Unit: Service and Repair
SRS Unit Removal and Installation
Removal:
CAUTION:
-
Before disconnecting the airbag connector(s), turn off the ignition switch and wait for at least 3 minutes to let the capacitor in the
back-up circuit discharge. This will prevent a malfunction of the seat belt pretensioners.
-
Before disconnecting any part of the SRS wire harness, install short connectors (RED) on the air- bag(s) and both seat belt
pretensioners. After installing the short connector(s) on the airbag(s), immediately install one Short Connector "A" (Tool Number
O7MAZSPOO2OO) on the cable reel connector (for the driver's airbag), and another on the SRS main harness connector (for the
passenger's airbag). This will prevent any static electricity from triggering the seat belt pretensioners before you disconnect them -
refer to "Short Connector Installation" procedure.
-
Do not damage the SRS unit terminals or connectors.
-
Do not disassemble the SRS unit; it has no serviceable parts.
-
Store the SRS unit in a clean, dry area.
-
Do not use any SRS unit which has been subjected to water damage or shows signs of being dropped or improperly handled, such as
dents, cracks or deformation.
NOTE: Before you disconnect the battery cable, be sure you get the customer's anti-theft radio code number.
1. Disconnect the battery negative cable, then the positive cable.
2. Install the short connectors on the airbag(s), and the seat belt pretensioners - refer to "Short Connector Installation" procedure.
3. Remove the center armrest, then disconnect the SRS main harness 18-P connector from the SRS unit.
4. Remove the 4 SRS unit mounting bolts, then remove the SRS unit.