Legend Coupe V6-3206cc 3.2L SOHC FI (1991)
7.
With the water and air valves OFF, attach the water and air supply to the flusher (hot water if available).
8.
Turn on the flusher's water valve for 10 seconds so water flows through the cooler.
NOTE:
If water does not flow through the cooler it is completely clogged and must be replaced.
9.
Depress the flusher's trigger and slip the wire clip over it.
10.
While flushing the system for two minutes, every 1 5 to 20 seconds turn on the air valve for five seconds to create a surging action (air pressure
max. 120 psi).
11.
Turn off the water valve and release the trigger.
12.
Reverse the hoses in order to flush in the opposite direction. Then repeat steps 8 through 10.
13.
Release the trigger and allow only water to rinse the cooler for one minute.
14.
Turn off the water valve and water supply.
15.
Turn on the air valve for approximately two minutes or until no moisture is seen coming out of the drain hose.
CAUTION:
Residual moisture in the cooler or pipes can cause damage to the transmission.
16.
Remove the flusher from the cooler's inlet line.
17.
Attach the drain hose to an oil can.
18.
Reinstall the transmission and inlet line and leave the drain hose attached to the cooler.
19.
Make sure the transmission is in Park. Then fill the transmission with ATF and run the engine for 30 seconds or until approximately one quart is
discharged.
20.
Remove the drain hose and reconnect the cooler's return hose to the transmission.
21.
Refill the transmission with ATF to the proper level.
22.
Clean the flusher using the procedure under TOOL MAINTENANCE.
TOOL MAINTENANCE
1.
Fill the tank with water and pressurize it.
2.
Depress the trigger and flush the discharge hose. If the discharged water does not foam, then the orifice is blocked.
