Legend Coupe V6-3206cc 3.2L SOHC FI (1991)
CV Joint Cross Section
12.
Insert the driveshaft in the new outboard joint. Make sure the "C" clip is centered on the shaft and is resting against the chamfered edge of the
inner race.
CV Joint Assembling
13.
To drive the outboard joint on the rest of the way, pick up the assembly and let it fall from about 10 cm (4 to 5 inches) onto a hard surface.
[NOTICE]
Do not use a hammer; excessive force may damage the driveshaft.
Spline Measurement
14.
Measure distance "A" (from the end of the splines to the inner race of the joint). If the distance is more than your measurement in Step 3, repeat
Step 13.
15.
When distance "A" equals your measurement in Step 3, the "C" clip should be seated in the joint. Tap on the inner race with a plastic hammer to
