Legend Sedan V6-3206cc 3.2L SOHC FI (1995)
Air Bag Control Module: Service and Repair
SRS Unit Replacement
CAUTION
-
Before disconnecting any part of the SRS wire harness, install the short connectors on the airbags and seat belt pretensioners.
-
Do not damage the SRS unit terminals or connectors.
-
Do not disassemble the SRS unit: it has no serviceable parts.
-
Store the SRS unit in a clean, dry area.
-
Do not use any SRS unit which has been subjected to water damage or shows signs of being dropped or improperly handled. such as dents
cracks or deformation
NOTE: The original radio has a coded theft protection circuit. Be sure to get the code number before disconnecting the battery cables.
1. Disconnect the battery negative cable, then the positive cable.
2. Before disconnecting any part of the SRS wire harness, connect the short connectors - refer to the "Short Connector Installation" procedure.
3. Remove the center armrest, then disconnect the SRS main harness 18-P connector from the SRS unit.
4. Remove the four SRS unit Torx bolts, then remove the SRS unit.
