Legend Sedan V6-3206cc 3.2L SOHC FI (1995)
Clockspring Assembly / Spiral Cable: Service and Repair
Cable Reel Replacement
WARNING: Store a removed airbag assembly with the pad surface up. If the airbag is improperly stored face down, accidental deployment
could propel the unit with enough force to cause serious injury.
CAUTION:
-
Carefully inspect the airbag assembly before installing it. Do not install an airbag assembly that shows signs of being dropped or
improperly handled, such as dents, cracks or deformation.
-
Always keep the short connectors on the airbags and seat belt pretensioners when the harness is disconnected.
-
Do not disassemble or tamper with any airbag assembly.
NOTE (L and LS models): Before disconnecting the battery cables, be sure you get the customer's anti-theft radio code number.
1. Disconnect the battery negative cable and then the positive cable.
2. Make sure the wheels are aligned straight ahead.
3. Remove the dashboard lower cover and glove box.
4. Before disconnecting any part of the SRS wire harness, install the short connectors - refer to the "Short Connector Installation" procedure.
5. Remove the driver's airbag assembly from the steering wheel (two T30 TORX® bolts), then remove the steering wheel nut.
6. Disconnect the connectors from the horn and cruise control set/resume switches, then remove the cable reel 3-P connector from its clips.
