Legend Sedan V6-3206cc 3.2L SOHC FI (1995)
NOTE: After installation, check that the shims are installed properly and the steering angle sensor contacts with the bracket.
CAUTION: Do not apply grease or adhesive agent to the adjustment shims with the intention of holding the shims in place or prevention of the
shims from dropping.
5. Connect the steering angle sensor 5P connector.
6. Install the column cover.
7. Perform the steering angle sensor system check to check that the steering angle sensor functions properly. If there is a problem, perform the
troubleshooting for Diagnostic Trouble Code (DTC) 2- 1.
Adjustment Shim Selection
NOTE: The steering shaft-to-steering angle sensor clearance is controlled to stabilize the output of the steering angle sensor. Select the correct
adjustment shims that match with the respective matching marks stamped on the steering column.
CAUTION: It is necessary to select the shims only when the steering column assembly (without the steering angle sensor) has been replaced. Use
the original adjustment shims when the steering angle sensor is replaced.
The matching marks (numerical letter 1 through 8) are stamped on the steering column as shown.
Select the adjustment shims according to the tables.
