MDX V6-3.7L (2007)
18.
Follow the screen prompts on the iN workstation to download the latest sofiware to the GNA6OO unit. The on-screen messages indicate if the
AcuraLink control unit has the latest software programs.
^
If the AcuraLink control unit has the latest sofiware programs, go to step 23.
^
If you see a screen that says, "Current Main [or Sub] Program ID Not Found" or Current Sub- Program ID Not Found," select Enter to
continue.
19.
Disconnect the USB PC interface cable and the power supply cord from the GNA600.
At the vehicle: Updating the software in the AcuraLink control unit
20.
Reconnect the DLC cable to the GNA6OO.
21.
Within 30 seconds of the LEDs on the GNA6OO flashing green and yellow, reconnect the yellow No.3 connector of the AcuraLink
reprogramming cable to the yellow connector of the reprogramming cable adapter.
NOTE:
The time to update the software in the AcuraLink control unit varies, depending on the size of the main and sub-update programs.
22.
After the yellow LEDs on the GNA600 stay on, disconnect the DLC cable from the GNA600. The AcuraLink control unit has been updated.
*23. Disconnect both reprogramming cable connectors from the vehicle, then wait at least 20 seconds before reconnecting the AcuraLink 5P
connectors.*
24.
Reattach the 5P connector to its mounting location to prevent rattles.
25.
Disconnect the reprogramming cable from the DLC cable before storing the GNA600 kit components.
Verifying the AcuraLink system operation
26.
Do the AcuraLink self-diagnosis:
*
All models except 2009 RL, 2009 TL, and 2009 TSX
^
Turn the ignition switch to ON (II), and accept the navigation system disclaimer.
