MDX V6-3.7L (2007)
5. Measure the resistance between the tweeter (A) terminal No. 2 and the outside terminal of the capacitor.
There should be about 6 ohms.
6. If the resistance is not as specified, replace the tweeter.
Satellite Speaker
1. Remove the quarter pillar trim.
2. Remove the speaker grille (A) and connector clip (B).
3. Remove the screws and the satellite speaker (C).
4. Measure the resistance between the No. 1 and No. 2 terminals there should be about 4 ohm.
5. If the resistance is not as specified, replace the satellite speaker.
Subwoofer/amplifier unit (With navigation)
1. Remove the right rear side trim panel.
2. Disconnect the 8P connector (A), then remove the bolts, nuts and pull out the subwoofer (B).
