MDX V6-3.7L (2007)
1.
Remove the front door panel:
^
Refer to steps 1 thru 6 on page 20-9 of the 2007-08 MDX Service Manual, or
^
Online, enter keywords DOOR PANEL, and select Front Door Panel Removal/Installation from the list.
2.
Replace the front door inner weatherstrip:
^
Remove the front door inner weatherstrip by straightening the tabs with a screwdriver, noting the direction the tabs are bent. Remove any EPT
sealer attaching the front door inner weatherstrip to the door panel, then pull the weatherstrip off the door panel.
^
Install the front door inner weatherstrip by pressing it against the door panel, then bend the tabs with your finger. Make sure you bend the tabs
in the same direction as the original weatherstrip's tabs.
^
Cut two 35 mm x 10 mm pieces of EPT sealer, and attach one piece to each end of the inner weatherstrip and door panel as shown.
