MDX V6-3.7L (2007)
9. While pulling the outer handle, remove it from the holes in the door panel. Take care not to scratch the door.
10. Install the rod fastener and the door handle, then torque the outer handle protector bolt to 9.8 N.m (7.2 lb-ft).
11. Reinstall the spacer, and torque the bolt to 9.8 N.m (7.2 lb-ft).
12. Reinstall the latch, and torque the screws to 6 N.m (4 lb-ft).
13. Reinstall the cap, and reattach the outer handle rod to the rod fastener.
14. Reconnect the power door lock actuator.
15. Reinstall the cap, the plastic cover, and the door panel.
Disclaimer
