MDX V6-3.7L (2007)
Rear Door Panel: Service and Repair
Rear Door Panel Removal/Installation
Special Tools Required
KTC trim tool set SOJATP2014 *
Trim pad remover. Snap-on A 177A or equivalent, commercially available
* Available through the American Honda Tool and Equipment Program
NOTE: Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
1. Using a trim tool, push on the upper hook (A) and pivot the inner handle cap (B) on the bottom hooks (C), then remove the cap and the screws
securing the inner handle (D).
2. Pry out the bottom edge of the grip cover (A) at the notches with the trim tool to detach the clips and to release the hooks (B). Then remove the
cover.