MDX V6-3.7L (2007)
Passenger Assist Handle: Service and Repair
Grab Handle Removal/Installation
Special Tools Required
KTC trim tool set SOJATP2014 *
* Available through the American Honda Tool and Equipment Program
NOTE: Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
1. Lower the grab handle (A), then pull out the caps (B) by prying up at the notches (C) with a small flat-tip screwdriver.
2. While pinching the clips (A), release the hooks (B), then remove the grab handle (C).
3. Using a pair of pliers, remove all of the clips (A) by pinching its hooks.
4. If the side curtain airbag has deployed, replace the grab handle with a new one.