MDX V6-3.7L (2007)
1. Adjust the mirror to its fully upward position.
2. Separate the mirror holder from the mirror actuator.
^
Insert a long, thin, flat-tipped screwdriver (wrapped with protective tape) under the mirror holder, and between the mirror holder and mirror
actuator.
^
Separate the parts by twisting the screwdriver.
^
If the mirror glass doesn't come off, insert the screwdriver farther under the mirror holder, and twist again.
NOTE:
^
Use a flashlight to help you see the proper location for the screwdriver.
^
Do not pry up to separate the two parts, or you may break the mirror glass or the mirror actuator.
3. Disconnect the two mirror defogger connectors from the heater pad terminals.
4. Remove the mirror actuator from the mirror housing (three Torx screws).
5. Disconnect the two 4P connectors on the back of the mirror actuator.
