MDX V6-3.7L (2007)
10. Tie a string to the top end of the rear drain tube (A), then pull the drain tube down out of the pillar. Leave the string in the pillar to use when
reinstalling the drain tube.
11. Install the frame and drain tube in the reverse order of removal, and note these items:
-
Before installing the frame, clear the drain tubes and drain valves using compressed air.
-
When installing, tie the string that was left in the pillar to the top end of the new drain tube and pull it up into the roof.
-
Check the frame seal.
-
Clean the surface of the frame.
-
Make sure the connectors are plugged in properly.
-
When connecting the drain tube, slide it over the frame nozzle at least 10 mm (0.39 in.).
-
Install the tube clip (A) on the drain tube (B) as shown.
-
After all parts are installed, including the headliner, reset the moonroof control unit.
-
Adjust the glass height alignment.
12. Check for water leaks. Let the water run freely from a hose without a nozzle. Do not use a high-pressure spray.
