MDX V6-3.7L (2007)
2. Remove the two nuts securing the purge joint.
3. Remove the brake lines from the master cylinder.
4. Remove the timing belt.
5. Remove the rocker arm assembly.
6. Remove the rear camshaft pulley.
7. Remove the thrust cover (A), then remove the camshaft (B).
8. Install the camshaft in the reverse order of removal. Always use a new O-ring (C). Apply new engine oil to the journals and cam lobes.
9. Apply new engine oil to the threads of the camshaft pulley mounting bolt, then install the rear camshaft pulley.
10. Install the rocker arm assembly, then tighten the mounting bolts.
11. Install the timing belt.
12. Adjust the valve clearance.
13. Install the brake lines and do the brake system bleeding procedure.
14. Do the CKP pattern clear/CKP pattern learn procedure.
