MDX V6-3.7L (2007)
2. Install the crankshaft pulley, and tighten the bolt. Do not use an impact wrench.
-1 Hold the pulley with the holder handle (A) and holder attachment (B). Torque the bolt to 65 N-m (6.5 kgf-m, 47 lbf-ft) with a torque wrench
and heavy duty 19 mm socket (C).
-2 Mark the bolt head (D) and crankshaft pulley (E) as shown, then tighten the bolt an additional 60° (The mark on the bolt head lines up with
the mark on the crankshaft pulley).
3. Install the drive belt.
4. Install the splash shield.
5. Install the right front wheel.
