MDX V6-3.7L (2007)
15. Place a rag or shop towel over the quick-connect fitting (A).
16. Disconnect the quick-connect fitting (A): Hold the connector (B) with one hand, and squeeze the retainer tabs (C) with the other hand to release
them from the locking tabs (D). Pull the connector off.
NOTE:
-
Be careful not to damage the line (E) or other parts.
-
Do not use tools.
-
If the connector does not move, keep the retainer tabs pressed down, and alternately pull and push the connector until it comes off easily.
-
Do not remove the retainer from the line; once removed, the retainer must be replaced with a new one.
17. After disconnecting the quick-connect fitting, check it for dirt or damage.
18. Reconnect the negative cable to the battery, then do this:
-
Enter the anti-theft code for the audio system and the navigation system (if equipped).
-
Set the clock.
Without the HDS
1. Make sure you have the anti-theft code for the audio system and the navigation system (if equipped).
2. Remove PGM-FI main relay 2 (G) from the under-dash fuse/relay box.