MDX V6-3.7L (2007)
Map Light: Service and Repair
Rear Individual MAP Light Test/Replacement
Rear Individual Map Light Test/Replacement
1. Turn the ceiling light switch OFF.
2. Carefully pry off the lens (A) with a small screwdriver.
3. Remove the two mounting screws.
4. Disconnect the 3P connector (B) from the housing (C).
5. Check for continuity between the terminals.
-
There should be continuity between the No. 1 and No. 3 terminals with the left switch ON.
-
There should be continuity between the No. 1 and No. 2 terminals with the right switch ON.
6. If the continuity is not as specified, check the bulb(s) (D). If the bulbs are OK, replace the light.
7. Install in the reverse order of removal.