MDX V6-3.7L (2007)
7. Release the brake disc (B) from the hub.
NOTE: If the brake disc is stuck to the hub. Screw two 8 x 1.25 mm bolts (C) into the brake disc to push it away from the hub. Turn each bolt 90
degrees to prevent the brake disc from binding.
8. Remove the hub bearing unit (A) and the splash guard (B) from the knuckle.
9. Check the hub bearing unit for damage and cracks.
10. Install the hub bearing unit in the reverse order of removal, and note these items:
^
Tighten all mounting hardware to the specified torque values.
^
Use a new spindle nut, apply a small amount of engine oil to the seating surface of the nut. After tightening, use a drift to stake the spindle nut
shoulder against the driveshaft.
^
Before installing the brake disc, clean the matching surfaces of the hub bearing unit and the inside of the brake disc.
^
Before installing the wheel, clean the mating surface of the brake disc and the inside of the wheel.
^
Check the wheel alignment, and adjust it if necessary.
Knuckle Replacement
1. Remove the hub bearing unit.
2. Remove the wheel sensor (A) from the knuckle (B). Do not disconnect the wheel sensor connector.
