MDX V6-3.7L (2007)
Multiple Junction Connector: Procedures
How to Install Pigtail Terminals
HOW TO INSTALL PIGTAIL TERMINALS
Pigtail terminals (short pieces of wire with a factory crimped terminal) are used when the wire is too short or when access to the connector is too
restricted to make a terminal repair.
NOTE: To replace just a connector terminal, go to How to Replace Connector Terminals.
IMPORTANT SAFETY INFORMATION:
On some models, the SRS wires are in a separate harness. If the SRS harness is damaged, replace the harness; do not repair it. On other
models, wire harnesses include yellow SRS wires. If any SRS wire is damaged, replace the entire harness; do not repair it.
1. Remove the damaged or faulty terminal from the connector. Use the proper removal tool from Pin Tool Set.
2. Cut off the wire about an inch back from where it connects to the damaged or faulty terminal, then strip about half of the insulation off that piece.
This will be used to size the wire end of the replacement pigtail terminal.
NOTE: If you are not sure of the wire size, start with a large enough hole on the stripper that will not nick or cut off any strands of wires.
