MDX V6-3.7L (2007)
8. Put the splice connector in the proper size slot in the Crimper Tool, slide it to one end (where the flare begins), and close the crimper handles far
enough to hold it in place. To release the ratchet mechanism at any point after the first click, squeeze the handles slightly and push the release
lever, then let the handles open.
9. Insert one of the bare wires into the splice connector end that is in the crimper jaws. Push the wire all the way into the splice connector, and
squeeze the crimper handles. Keep squeezing until the jaws touch, and hold it at that position until the ratchet clicks again.
10. Crimp the other wire in the same way into the other end of the splice connector.
11. After crimping, gently pull on the wires in the opposite directions to make sure they are secure in the connector.
