MDX V6-3.7L (2007)
Information Bus: Component Tests and General Diagnostics
Driver's MPCS Unit Input Test
Driver's MPCS Unit Input Test
NOTE: Before testing, troubleshoot the B-CAN System Diagnosis Test Mode A.
1. Turn the ignition switch OFF.
2. Remove the driver's door panel.
3. Disconnect the driver's MPCS unit connectors A (40P) and B (14P).
4. Inspect the connector and socket terminals to be sure they are all making good contact.
-
If the terminals are bent, loose or corroded, repair them as necessary and recheck the system.
-
If the terminals look OK, go to step 5.
5. With the connectors still disconnected, make these input tests at the connectors.
-
If any test indicates a problem, find and correct the cause, then recheck the system.
-
If all the input tests prove OK, go to step 6.
6. Reconnect the connectors, and make these input tests at the connectors.
-
If any test indicates a problem, find and correct the cause, then recheck the system.
-
If all the input tests prove OK, replace the driver's MPCS unit.